Use the lsroute command to display the IP routing table.
Syntax
lsroute [ -delimdelimiter ] [ -nohdr ]
Parameters
- -nohdr
- (Optional) By default, headings are displayed for each column of data in a concise style
view, and for each item of data in a detailed style view. The -nohdr
parameter suppresses the display of these headings.
Note: If there is no data to be displayed,
headings are not displayed.
- -delim delimiter
- (Optional) By default in a concise view, all columns of data are space-separated. The width
of each column is set to the maximum width of each item of data. In a detailed view, each item
of data has its own row, and if the headers are displayed, the data is separated from the
header by a space. The -delim parameter overrides this behavior. Valid
input for the -delim parameter is a 1-byte character. If you enter
-delim : on the command line, the colon character (:)
separates all items of data in a concise view; for example, the spacing of columns does not
occur. In a detailed view, the data is separated from its header by the specified
delimiter.
Description
This command displays the IP
routing table. The table provides details of the gateway that is used for IP traffic to a range
of IP addresses for each Ethernet port. This information can be used to diagnose configuration
node accessibility problems. The lsroute command is equivalent to the Linuxroute command.
An invocation example
lsroute
The resulting
output:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
9.71.46.0 0.0.0.0 255.255.254.0 U 0 0 0 eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 9.71.46.1 0.0.0.0 UG 0 0 0 eth0
Kernel IPv6 routing table
Destination Next Hop Flags Metric Ref Use Iface
2002:914:fc12:849::/64 :: UA 256 3675 0 eth0
fe80::/64 :: U 256 0 0 eth0
::/0 fe80::7:b4ff:fe00:500 UGDA 1024 1 0 eth0
::1/128 :: U 0 1441 1 lo
2002:914:fc12:849:214:5eff:fe33:5192/128 :: U 0 0 1 lo
fe80::214:5eff:fe33:5192/128 :: U 0 0 1 lo
ff00::/8 :: U 256 0 0 eth0