Use the chnodeled command
to turn the identification light-emitting diode (LED) on or off for the specified node or control
canister.
Syntax
sataskchnodeled { -on | -off } [ panel_name ]
Parameters
- -on | -off
- (Required) Turns the identification LED for the specified node or control canister
on or off.
- panel_name
- (Optional) Specifies a unique panel name used to apply the command to a valid node on the
fabric.
Note: If panel_name is not supplied, this applies to the node on
which the command is running.
Description
This command turns the canister identification LED on or off.
Note: The identification LED is
mapped onto the physical LEDs using different methods, depending on your hardware. Refer to the
documentation for your hardware platform for more information.
An invocation example to turn on the LED to identify the battery
in slot 2 on node KP2812
satask chnodeled -on -battery 2 KP2812
The resulting
output:
No feedback
An invocation example to turn on the LED to identify the battery
on node 2
satask chnodeled -on -battery 2
The
resulting output:
No feedback
An invocation example to allow the node to identify the
LED
satask chnodeled -on
The resulting
output:
No feedback
An invocation example to turn on the LED for canister 1 in control
enclosure 02
satask chnodeled -on 02-1
The resulting output:
No feedback