mkcluster

Use the mkcluster command to create a new clustered system (system).

Syntax

 satask   mkcluster     -clusterip   -ipv4_ip     -gw   -ipv4_gw   -mask    ipv4_mask    [  -name cluster_name ]   [  panel_name  ]  
 satask   mkcluster     -clusterip_6     ipv6_ip     -gw_6   ipv6_gw   -prefix_6     ipv6_subnet    [  -name cluster_name ]   [  panel_name  ]  

Parameters

-clusterip ipv4_ip
(Optional) The Internet Protocol Version 4 (IPv4) address for system Ethernet port 1.
-gw ipv4_gw
(Optional) The IPv4 gateway for system Ethernet port 1.
-mask ipv4_mask
(Optional) The IPv4 subnet for system Ethernet port 1.
-clusterip_6 ipv6_ip
(Optional) The Internet Protocol Version 6 (IPv6) address for system Ethernet port 1.
-gw_6 ipv6_gw
(Optional) The IPv6 gateway for system Ethernet port 1.
-prefix_6 ipv6_subnet
(Optional) The IPv6 prefix for system Ethernet port 1.
-namecluster_name
(Optional) The name of the new system.
panel_name
(Optional) Identifies the node being serviced.
Note: If panel_name is not supplied, this applies to the node on which the command is running.
Remember: You must specify one of the following:
  • IPv4 system IP, gateway and subnet
  • IPv6 system IP, gateway, and prefix

Description

This command creates a new system.

An invocation example using specific -clusterip, -gw, and -mask parameters

satask mkcluster -clusterip 192.168.1.2 -gw 192.168.1.1 -mask 255.255.255.0

The resulting output:

No feedback