Add a Lenovo Storage V7000 Gen1 control enclosure
to an existing system.
To complete this step, you must use a supported web browser.
Verify that you are using a supported web browser from the following
website:
http://support.lenovo.com/us/en/products/servers/lenovo-storage
Note: When you add another control enclosure,
you do not use the initialization tool or
the USB flash drive.
To add another control enclosure into an existing system,
complete the following steps:
- Configure the Fibre Channel switch to allow for correct
zoning between the control enclosures.
The correct zoning
provides a way for the Fibre Channel ports to connect to each other.
If
the configuration tool for the Fibre Channel switch does not provide
details of the world wide port names (WWPNs), use the service assistant
to find them or use the USB flash drive to
find the status of the node. See
the "Troubleshooting" topic that is available from the Lenovo Storage V7000 Information
Center.
- Start the management GUI.
- Go to .
- On the System page,
select .
- Continue to follow the on-screen instructions.
This step completes
the quick installation procedures. If you are setting up for the first
time, see the configuring topics and continue to follow the tasks
available in Getting Started from the management GUI.
If you added another control enclosure into an existing system, continue
to do your standard tasks.