You must configure the operating system before you can use hosts that run
the Linux operating system with the
system.
Before you configure the host operating systems, the following tasks must be completed:
- Your system must be installed.
- You must install the appropriate host bus adapters.
After the prerequisite tasks are complete, use the following
general steps to configure your host system:
- Zone the host to the system on the Fibre Channel SAN.
For more information, see the zoning details and zoning examples topics in the Configuring
section of this product information.
- Install a multipathing driver that is supported for Linux to enable the management of multiple
paths to system volumes.
- Create the host on the system by using the worldwide port names (WWPNs). Map the volumes to the
host.
For more information, see the documentation on software installation and configuration, and
on the command-line interface.
- Create volumes or disks on your host by using a logical volume manager (LVM) or partition and
create file systems on the disks.