Use this information to replace a SD adapter.
Important: If your SD adapter option comes with
VMware vSphere ESXi software preloaded, you must make configuration
changes to your system UEFI
before installing the SD adapter
in your compute node. See the documentation that comes with the SD
adapter and
Using the Setup Utility for information and instructions.
To install the SD adapter, complete the following steps:
- Read the safety information that begins on Safety and Installation guidelines.
- Turn off the server, and disconnect all power cords and
external cables.
- Remove the top cover (see Removing the top cover).
- Remove the riser-card assembly 2 (See Removing a riser-card assembly).
- Insert the SD cards.
- Align the SD adapter with the alignment pin and the connector;
then, lower the SD adapter and push it until it is firmly seated.
- Fasten two screws.
Figure 1. SD adapter installation
- See the http://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5096845,
that comes with the option, for information about how to configure
the SD adapter.
- Turn on the peripheral devices and the server.