Replacing a USB embedded hypervisor flash device

Use this information to replace a USB embedded hypervisor flash device.

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the top cover (see Removing the top cover).
4. Remove the riser-card assembly (see Removing a riser-card assembly).
5. Install the flash device:
   Figure 1. USB hypervisor flash device installation
   
   
   1. Align the flash device with the connector on the system board and push it into the USB connector until it is firmly seated.
   2. Pull up the blue locking collar to lock the flash device into the USB connector.
6. Reconnect the power cords and any cables that you removed.
7. Replace the top cover (see Replacing the top cover).
8. Slide the server into the rack.
9. Turn on the peripheral devices and the server.