Use this information to start the LSI Configuration Utility
program.
To start the LSI Configuration Utility program, complete
the following steps:
- Turn on the server.
Note: Approximately 20
to 40 seconds after the server is connected to power, the power-control
button becomes active.
- When the prompt <F1 Setup> is displayed,
press F1. If you have set an administrator password, you are prompted
to type the password.
- Select .
- Select Please refresh this page on the first
visit and press Enter.
- Select LSIcontroller_driver_name
Driver and press Enter, where controller_driver_name is
the name of the SAS/SATA controller driver. For the SAS/SATA controller
driver name, see the documentation that comes with your controller.
- To perform storage-management tasks, follow the procedures
in the documentation that comes with the SAS/SATA controller.
When you have finished changing settings, press Esc to
exit from the program; select Save to save
the settings that you have changed.