Removing the system battery

Use this information to remove the system battery.

The following notes describe information that you must consider when replacing the battery:

• IBM has designed this product with your safety in mind. The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you must adhere to the following instructions.
  Note

  In the U. S., call 1-800-IBM-4333 for information about battery disposal.
• If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal components, be aware of the following environmental consideration. Batteries and accumulators that contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper manner.
• To order replacement batteries, call 1-800-IBM-SERV within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your support center or business partner.
  Note

  After you replace the battery, you must reconfigure the server and reset the system date and time.

Statement 2

CAUTION

When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:

• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

To remove the system-board battery, complete the following steps:

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see Removing the cover).
4. If necessary, lift the PCI riser-card assembly out of the way (see Removing a PCI riser-card assembly).
5. Remove the system-board battery:
   Figure 1. Battery location
   
   
   1. If there is a rubber cover on the battery holder, use your fingers to lift the battery cover from the battery connector.
   2. Use one finger to push the battery horizontally away from the PCI riser card in slot 2 and out of its housing.
      Attention

      Neither tilt nor push the battery by using excessive force.

      Figure 2. Battery removal
      
      
   3. Use your thumb and index finger to lift the battery from the socket.
      Attention

      Do not lift the battery by using excessive force. Failing to remove the battery properly may damage the socket on the system board. Any damage to the socket may require replacing the system board.
6. Dispose of the battery as required by local ordinances or regulations. See the IBM Environmental Notices and User's Guide on the IBM System x Documentation CD for more information.