Removing the 240 VA safety cover

Use this information to remove the 240 VA safety cover.

To remove the 240 VA safety cover, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
  3. Remove the cover (see Removing the cover).
  4. Remove the SAS/SATA riser-card assembly (see Removing the SAS/SATA RAID riser-card assembly).
  5. Remove the screw from the safety cover.
    Figure 1. Safety cover removal
    Safety cover removal
  6. Disconnect the hard disk drive backplane cables from the connector on the front of the safety cover.
  7. Slide the safety cover forward to disengage it from the system board, then lift it out of the server.

If you are instructed to return the safety cover, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.