Skip to main content

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

To install a hypervisor flash device, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect the power cords.
  3. Remove the cover (see Removing the cover).
  4. Align the flash device with the connector on the SAS/SATA RAID riser-card assembly and push it into the connector until it is firmly seated.
  5. Slide the blue lockbar toward the flash device to the locked position until it is seated firmly.
    Figure 1. USB embedded hypervisor flash device installation
    USB embedded hypervisor flash device installation

If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.