Installing the virtual media key

Use this information to install the virtual media key.

To install the virtual media key, complete the following steps:

1. Read the safety information that begins on Safety and Installation guidelines.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see Removing the cover).
4. Align the virtual media key with the mounting tab and slide it down the tab onto the connector on the system board. Press the virtual media key down into the connector until it is firmly seated on the system board.
   Figure 1. Virtual media key installation
   
   
5. Replace the cover (see Installing the cover).
6. Slide the server into the rack.
7. Reconnect the power cord and any cables that you removed.
8. Turn on the peripheral devices and the server.