Skip to main content

Installing a DIMM

Use this information to install a DIMM.

To install a DIMM, complete the following steps:

  1. Read the safety information that begins on Safety and Installation guidelines.
  2. Turn off the server and peripheral devices and disconnect the power cords and all external cables, if necessary.
  3. Remove the cover (see Removing the cover).
  4. Open the retaining clip on each end of the DIMM connector.
    Attention
    To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently.
    Figure 1. DIMM installation
    DIMM installation
  5. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the outside of the server. Then, remove the DIMM from the package.
  6. Turn the DIMM so that the DIMM keys align correctly with the connector.
  7. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector (see System-board optional device connectors for the locations of the DIMM connectors).
  8. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector.
    Note
    If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it.

If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.