Use this information to replace the cover.
To replace the server cover, complete the following steps:
- Make sure that all cables, adapters, and other components
are installed and seated correctly and that you have not left loose
tools or parts inside the server. Also, make sure that all internal
cables are correctly routed.
- Align the cover over the server (toward the rear of the
server) until the cover edges slip into position over the chassis.
Important: Before you slide the cover forward, make
sure that all the tabs on the cover engage the chassis correctly.
If all the tabs do not engage the chassis correctly, it will be hard
to remove the cover later.
Figure 1. Cover installation
- Slightly slide the cover toward the front of the server
until the inset tabs start to engage on the server; then, tighten
the thumbscrews to secure the cover to the chassis.
- Install the server into the rack enclosure and push the
server into the rack until it clicks into place.