Through the Setup utility, you can access utilities to configure
RAID arrays. The specific procedure for configuring arrays depends
on the RAID controller that you are using. For details, see the documentation
for your RAID controller. To access the utility for your RAID controller,
complete the following steps:
- Turn on the server.
Note: Approximately 1 to 3 minutes
after the server is connected to ac power, the power-control
button becomes active.
- When prompted, <F1> Setup is displayed, press F1.
If you have set an administrator password, you must type the administrator
password to access the full Setup utility menu. If you do not type
the administrator password, a limited Setup utility menu is available.
- Select System Settings → Adapters and
UEFI drivers.
- Press Enter to refresh the list of device drivers.
- Select the device driver for your RAID controller and press Enter.
- Follow the instructions in the documentation for your RAID controller.