Skip to main content

W.50001 : [W.50001] A DIMM has been disabled due to an error detected during POST.

[W.50001] A DIMM has been disabled due to an error detected during POST.

DIMM Disabled

Severity

Info

User Response

Complete the following steps:

  1. If the DIMM was disabled because of a memory fault, follow the procedure for that event.
  2. If no memory fault is recorded in the logs and no DIMM connector error LEDs are lit, re-enable the DIMM through the Setup utility or the Advanced Settings Utility (ASU).
  3. If problem persists, Power cycle the node.
  4. Reset IMM to default settings.
  5. Reset UEFI to default settings.
  6. Reflash IMM and UEFI firmware.
  7. (Trained Service technician only) Replace system board.