Use this information to replace the RAID adapter battery
or flash power module holder in the server.
Note: RAID adapter battery or flash power module holder
is only supported in the 2.5-inch models.
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the server,
you need to slide the server out from the rack enclosure, turn off
the server and peripheral devices, and disconnect the power cords
and all external cables.
To replace the RAID adapter battery or flash power module
holder, complete the following steps:
- Align the holder and place the holder on the system tray.
Figure 1. RAID adapter battery or flash power module holder installation
- Fasten the two screws come with the holder and make sure
that the holder is secured firmly on the system tray.
- Reinstall the remotely installed RAID adapter battery or
flash power module (see Replacing a RAID adapter battery or flash power module).
- Install the retainer.
- Reinstall the cover (see Replacing the cover).
What to do next
- Install the server into the rack enclosure and push the server
into the rack until it clicks into place.
- Reconnect the power cords and any cables that you removed.
- Turn on the peripheral devices and the server.