Replacing the bezel

Use this information to replace the bezel.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To replace the bezel, complete the following steps.

1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
2. Rotate the bezel upward to the server and reinstall the bezel screws.
   Figure 1. Bezel installation
   
   
3. Reinstall the drives and drive bay filler panels into the drive bays (see Replacing a hot-swap hard disk drive, or Replacing a simple-swap hard disk drive, or Replacing the optional DVD drive).
4. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
5. Reconnect the power cords and any cables that you removed.
6. Turn on the peripheral devices and the server.