Use this information to remove the DVD drive cable.
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the server,
you need to slide the server out from the rack enclosure, turn off
the server and peripheral devices, and disconnect the power cords
and all external cables.
To remove the DVD drive cable, complete the following
steps:
- Remove the cover (see Removing the cover).
- Remove the DVD drive bay filler panel from the server.
- Disconnect the DVD drive cable from the system board.
Attention: Do not disconnect the DVD drive cable
by using excessive force.
Figure 1. DVD drive cable connection
- From the rear of the DVD drive cage, press and hold the
connector latch (on the left of the cable connector) and grasp the
cable connector and slide the cable connector to the right (unlocked
position). Remove the DVD drive cable from the connector on the back
of the DVD drive and set the cable aside.
Figure 2. DVD drive cable latch
If you are instructed to return the server component
or optional device, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.