Removing the 240 VA safety cover

Use this information to remove the 240 VA safety cover.

Read the safety information in Safety and Installation guidelines.

If you are replacing a server component in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

To remove the 240 VA safety cover, complete the following steps:

1. Remove the cover (see Removing the cover).
2. Remove any connected SAS/SATA signal cable and all other cables that pass through the safety cover (see Internal cable routing and connectors).
3. Remove the four screws from the safety cover.
   Figure 1. 240 VA safety cover's screws
   
   
4. Lift the safety cover up to remove it from the server.
   Figure 2. 240 VA safety cover removal
   
   

If you are instructed to return the server component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.