Installing the Operating temperature enhancement kit

Use this information to install the Operating temperature enhancement kit in the server.

Read the safety information in Safety and Installation guidelines.

If you are installing an optional device in the server, you need to slide the server out from the rack enclosure, turn off the server and peripheral devices, and disconnect the power cords and all external cables.

Figure 1. Operating temperature enhancement kit

To install the Operating temperature enhancement kit, complete the following steps.

1. Remove the cover (see Removing the cover).
2. Remove the PCI riser-card assembly (see Removing the PCI riser-card assembly).
3. Connect the Operating temperature enhancement kit to the system board (see System-board internal connectors for the location of the Operating temperature enhancement kit connector on the system board).
4. Route the cable along the chassis. Make sure the relevant cables pass through the cable clips.
   Figure 2. Operating temperature enhancement kit connection for 2.5-inch hard disk drive model
   
   

   Figure 3. Operating temperature enhancement kit connection for 3.5-inch hard disk drive model
   
   

   Attention

   Make sure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.
5. Route the cable through the cable holder and slide the Operating temperature enhancement kit into the connecting slot on the hard disk drive cage until the Operating temperature enhancement kit locks into place with an audible click.
   Figure 4. Operating temperature enhancement kit installation
   
   
6. Reinstall the PCI riser-card assembly (see Replacing the PCI riser-card assembly).

If you have other devices to install, do so now. Otherwise, go to Completing the installation.