Use this information to install an adapter.
The following notes describe the types of adapters that
the server supports and other information that you must consider when
you install an adapter:
- To confirm that the server supports the adapter that you are installing,
see the Lenovo ServerProven website.
- Locate the documentation that comes with the adapter and follow
those instructions in addition to the instructions in this section.
- The adapter slots are on the PCI riser-card assembly. You must
first remove the PCI riser-card assembly to access the adapter slots.
- The expansion slots on the PCI riser-card assembly accommodate
the various form factors of the non-hot-plug adapters as follows:
- PCI slot 1: Dedicated to ServeRAID H1110 SAS/SATA Controller
- PCI slot 2: Support one PCI Express Gen3 x8 half-length, full-height
adapter
Figure 1. PCI riser-card assembly
Read the safety information in Safety and Installation guidelines.
If you are installing an optional device in the server,
you need to slide the server out from the rack enclosure, turn off
the server and peripheral devices, and disconnect the power cords
and all external cables.
To install an adapter, complete the following steps.
- Remove the cover (see Removing the cover).
- Remove the PCI riser-card assembly (see Removing the PCI riser-card assembly).
- Touch the static-protective package that contains the adapter
to any unpainted metal surface on the server; then, remove the adapter
from the package.
- Place the adapter, component side up, on a flat, static-protective
surface and set any jumpers or switches as described by the adapter
manufacturer, if necessary.
- Remove the expansion-slot filler from the PCI riser-card
assembly and save for future use.
- Align the gold finger on the adapter with the connector
on the PCI riser-card assembly, then, insert the adapter into the
PCI riser-card assembly. Press the edge of the connector firmly into the PCI riser-card assembly. Make sure that the adapter is
securely installed in the PCI riser-card assembly.
Important: Make sure that the U-shaped opening in
the metal adapter bracket engages the tab on the expansion-slot filler.
Figure 2. Adapter installation
- Install the PCI riser-card assembly (see Replacing the PCI riser-card assembly).
Attention: When you install an adapter, make sure
that the adapter is correctly seated in the PCI riser-card assembly
and that the PCI riser-card assembly is securely seated in the riser-card
connector on the system board before you turn on the server. An incorrectly
seated adapter might cause damage to the system board, the PCI riser-card
assembly, or the adapter.
If you have other devices to install, do so now.
Otherwise, go to Completing the installation.
Note: If the server is configured for RAID operation through
an optional ServeRAID adapter, you might have to reconfigure your
disk arrays after you install an adapter. See the ServeRAID documentation
on the Lenovo ServerRAID Support CD for additional information
about RAID operation and complete instructions for using ServeRAID
Manager.