The internal routing and connectors for the simple-swap
hard disk drive with ServeRAID SAS/SATA controller (redundant power
supply model).
The following illustrations show the internal routing and connectors
for the 2.5-inch simple-swap hard disk drive models with ServeRAID
SAS/SATA controller.
Note: Make sure the relevant cables pass through the cable clips.
Figure 1. Four simple-swap hard disk drives with ServeRAID SAS/SATA controller
cable connection (hardware RAID card inserted on the right side)
Figure 2. Four simple-swap hard disk drives with ServeRAID SAS/SATA controller
cable connection (hardware RAID card inserted on the left side)
Figure 3. Eight simple-swap hard disk drives with ServeRAID SAS/SATA
controller cable connection (hardware RAID card inserted on the left
side)
Note: Make sure you connect the mini-SAS cable connector 0 to the
simple-swap hard disk drive backplate assembly 0 and the mini-SAS
cable connector 1 to the simple-swap hard disk drive backplate assembly
1.