Cabling the operator information panel cable

The internal routing and connectors for the operator information panel cable.

The following notes describe additional information you must consider when you install or remove the operator information panel cable:

• To remove the operator information panel cable on the system board, you have to press evenly on the release latch on the sides of the operator information panel cable connector before you can pull out and disengage the operator information panel cable connector from the operator information panel connector on the system board. Pulling the cable out of the connector by excessive force might cause damage to the cable or connector.
• To connect the operator information panel cable on the system board, press evenly on the release latch on the sides of the operator information panel cable connector. Pressing on one side of the cable connector might cause damage to the cable or connector.

The following illustration shows the internal routing and connectors for the operator information panel cable.

Note

Make sure the relevant cables pass through the cable clips.

Figure 1. Operator information panel cable connection