Through the Setup Utility, you can access utilities to
configure RAID arrays.
The specific procedure for configuring arrays depends
on the RAID card that you are using. For details, see the documentation
for your RAID card. To access the utility for your RAID card, do the
following:
- Turn on the server.
Note: Approximately 5 seconds after the server is connected
to power, the power-control button becomes active.
- When prompted, <F1 Setup> is displayed,
press F1. If you have set an administrator password, you must type
the administrator password to access the full Setup Utility menu.
If you do not type the administrator password, a limited Setup Utility
menu is available.
- Select .
- Select the device driver for your RAID card and press Enter.
Then, follow the instructions in the documentation for your RAID card.