The default settings for the Power Policy option are set
by the IMM2.1.
To change the Power Policy option to the default settings,
do the following:
- Turn on the server.
Note: Approximately 20 seconds after the server is connected
to ac power, the power-control button becomes active.
- When the prompt <F1> Setup is
displayed, press F1. If you have set an administrator password, you
must type the administrator password to access the full Setup Utility
menu; otherwise if you do not type the administrator password, a limited
Setup Utility menu is available.
- Select ,
and then set Power Restore Policy setting to Restore.
- Go back to .
- Go back and check the Power Policy setting to verify that it is set to Restore (the default).