Skip to main content

Hot-swap HDD cable connection: ServeRAID SAS/SATA controller and fixed power supply

  • 1: Connect to the backplane power connector on the system board and the power connector on the hard-disk-drive backplane.

  • 2: Connect to the connector 0 on the ServeRAID SAS/SATA controller and the Mini-SAS connector on the hard-disk-drive backplane.

Note

  • Ensure that the cable is not pinched and does not cover any connectors or obstruct any components on the system board.

  • Ensure the relevant cables pass through the cable clips.

Figure 1. Hot-swap HDD cable connection: 2.5-inch, ServeRAID SAS/SATA controller installed on the right side
Hot-swap HDD cable connection: 2.5-inch, ServeRAID SAS/SATA controller installed on the right side

Figure 2. Hot-swap HDD cable connection: 2.5-inch, ServeRAID SAS/SATA controller installed on the left side
Hot-swap HDD cable connection: 2.5-inch, ServeRAID SAS/SATA controller installed on the right side

Figure 3. Hot-swap HDD cable connection: 3.5-inch, ServeRAID SAS/SATA controller installed on the right side
Hot-swap HDD cable connection: 3.5-inch, ServeRAID SAS/SATA controller installed on the right side

Figure 4. Hot-swap HDD cable connection: 3.5-inch, ServeRAID SAS/SATA controller installed on the left side
Hot-swap HDD cable connection: 3.5-inch, ServeRAID SAS/SATA controller installed on the left side