Use this information to replace the operator information
panel assembly.
Read the safety information in Safety and Installation guidelines.
If you are replacing a server component in the server,
you need to turn off the server and peripheral devices, and disconnect
the power cords and all external cables.
To install the operator information panel assembly, complete
the following steps.
- Guide the operator information panel assembly into position
on top of the DVD drive housing. Make sure that the LEDs and the USB
connectors are aligned with the openings in the bezel and that the
screw holes in the operator information panel align with the screw
holes in the top of the DVD bay housing.
- Use the screws that you removed in Removing the operator information panel assembly to
secure the operator information panel assembly on the DVD bay housing.
- Connect the signal cable to the operator information panel
board.
- Install the server top cover (see Replacing the cover ).
- Reconnect the power cord and any cables that you removed.
- Turn on all attached devices and the server.
If you have replaced a server component or installed
an optional device in the server, you need to reconnect the power
cords and all external cables, and turn on the server and peripheral
devices.