Use this information to replace the cover.
Make sure that all cables, adapters, and other server
components are installed and seated correctly and that you have not
left loose tools or parts inside the server. Also, make sure that
all internal cables are correctly routed.
Important: Before
you slide the cover forward, make sure that all the tabs on the front,
rear, and side of the cover engage the chassis correctly. If all the
tabs do not engage the chassis correctly, it will be very difficult
to remove the cover later.
To replace the server cover, complete the following steps.
- Position the cover on top of the server so that approximately
13 mm (0.5 inch) extends from the rear.
- Slide the cover toward the front of the server.
Figure 1. Cover installation
- Make sure that the cover correctly engages all the inset
tabs on the server.
- Install the server into the rack enclosure and tighten
the two front thumbscrews to secure the server in the rack.
- Reconnect the external cables and power cords.
If you have replaced a server component or installed
an optional device in the server, you need to reconnect the power
cords and all external cables, and turn on the server and peripheral
devices.