Error codes and messages are displayed in POST event log,
system-event log, Integrated Management Module II (IMM2) event log, and DSA event log.
- POST event log: This log contains the most recent error
codes and messages that were generated during POST. You can view the
contents of the POST event log from the Setup utility (see Starting the Setup utility). For more information
about POST error codes, see UEFI (POST) error codes.
- System-event log: This log contains POST and system management
interrupt (SMI) events and all events that are generated by the baseboard
management controller that is embedded in the Integrated Management Module II (IMM2). You can view the contents of the system-event log through the Setup
utility and through the Dynamic System Analysis (DSA) program (as
IPMI event log).
The system-event log is limited in size. When it
is full, new entries will not overwrite existing entries; therefore,
you must periodically clear the system-event log through the Setup
utility. When you are troubleshooting an error, you might have to
save and then clear the system-event log to make the most recent events
available for analysis. For more information about the system-event
log, see Integrated Management Module II (IMM2) error messages.
Messages are listed on the left side of the screen,
and details about the selected message are displayed on the right
side of the screen. To move from one entry to the next, use the Up
Arrow (↑) and Down Arrow (↓) keys.
Some IMM2 sensors cause assertion events to be logged when their
setpoints are reached. When a setpoint condition no longer exists,
a corresponding deassertion event is logged. However, not all events
are assertion-type events.
- Integrated management module II (IMM2) event log: This
log contains a filtered subset of all IMM2, POST, and system management interrupt (SMI) events. You
can view the IMM2 event log through the IMM2 web interface. For more information, see Logging on to the web interface. You can also view
the IMM2 event log through the Dynamic System Analysis (DSA) program
(as the ASM event log). For more information about IMM2 error messages, see Integrated Management Module II (IMM2) error messages.
- DSA event log: This log is generated by the Dynamic System
Analysis (DSA) program, and it is a chronologically ordered merge
of the system-event log (as the IPMI event log), the IMM2 chassis-event log (as the ASM event log), and the operating-system
event logs. You can view the DSA event log through the DSA program
(see Viewing event logs without restarting the server).
For more information about DSA and DSA messages, see IBM Dynamic System Analysis and DSA diagnostic test results.