Server features and specifications - Lenovo System x3250 M4

The following information is a summary of the features and specifications of the server. Depending on the model, some features might not be available, or some specifications might not apply.

Table 1. Server features and specifications
Microprocessor (depending on the model): Supports one Intel quad-core (Xeon E3-1200 series) or dual-core (Pentium G850, or Core i3 series) processor Multi-chip Package processor architecture Designed for LGA 1155 socket Scalable up to four cores 32 KB instruction L1 cache, 32 KB data L1 cache, 256 KB instruction/data L2 cache, and up to 8 MB L3 cache that is shared among the cores Support for Intel Extended Memory 64 Technology (EM64T) Note: Use the Setup utility to determine the type and speed of the microprocessors in the server For a list of supported microprocessors, see the Lenovo ServerProven website. Memory: Minimum: 1 GB Maximum: 32 GB Types: PC3L-12800 (single-rank or dual-rank), 1333 or 1600 MHz, ECC, DDR3 unbuffered SDRAM DIMMs only Connectors: Four dual inline memory module (DIMM) connectors, two-way interleaved Sizes: 1 GB (single-rank), 2 GB (single-rank), 4 GB (dual-rank), and 8 GB (dual-rank)	Memory: UltraSlim DVD-ROM combo Multi-burner Hard disk drive expansion bays (depending on the model): One of the following configurations: Four 2.5-inch simple-swap SAS hard disk drive bays Four 2.5-inch hot-swap SAS hard disk drive bays Two 3.5-inch simple-swap SATA hard disk drive bays Attention: As a general consideration, do not mix standard 512-byte and advanced 4-KB format drives in the same RAID array because it might lead to potential performance issues. Note: 3TB hard disk drives are not supported in OS 4690. PCI expansion slots: Supports two PCI riser slots on the riser card: Slot 1 is dedicated for ServeRAID-10il V2 SAS/SATA controller Slot 2 supports one PCI Express Gen2 x8 half-length, full-height adapter Power supply (depending on the model): One fixed 300-watt power supply Up to two hot-swap 460-watt power supplies for redundancy Fan: The server comes standard with four speed-controlled fans.	Integrated functions: Integrated Management Module II (IMM2), which consolidates multiple management functions in a single chip Intel 82574L Gb Ethernet controller with TCP/IP Offload Engine (TOE) and Wake on LAN support Six Universal Serial Bus (USB) 2.0 ports (two front and four rear) Two Ethernet ports Six-port integrated SATA controller One serial port One VGA port RAID controllers (depending on the model): Software RAID capabilities that support RAID levels 0, 1, and 10 ServeRAID-BR10il v2 SAS/SATA adapter that provides RAID levels 0, 1, and 10
RAID controllers (depending on the model): Software RAID capabilities that support RAID levels 0, 1, and 10 ServeRAID-BR10il v2 SAS/SATA adapter that provides RAID levels 0, 1, and 10 Acoustical noise emissions: Sound power, idling: 6.5 bels maximum Sound power, operating: 6.5 bels maximum Environment: Air temperature: Server on: 10°C to 35°C (50.0°F to 95.0°F); altitude: 0 to 914.4 m (3000 ft) Server on: 10°C to 32°C (50.0°F to 89.6°F); altitude: 914.4 m (3000 ft) to 2133.6 m (7000 ft) Server on: 10°C to 28°C (50.0°F to 83°F); altitude: 2133.6 m (7000 ft) to 3050 m (10000 ft) Server off: 10°C to 43°C (50°F to 109.4°F) Shipping: -40°C to 60°C (-40°F to 140°F) Humidity: Server on: 8% to 80% Server off: 8% to 80% Particulate contamination: Attention: Airborne particulates and reactive gases acting alone or in combination with other environmental factors such as humidity or temperature might pose a risk to the server. For information about the limits for particulates and gases, see “Particulate contamination”.	Video controller (integrated into IMM2): Matrox G200 SVGA compatible video controller Avocent Digital Video Compression Video memory is not expandable Note: Maximum video resolution is 1600 x 1200 at 75 Hz. Size: 1U Height: 43 mm (1.69 inches) Depth: 575.8 mm (22.67 inches) Width: 439 mm (17.28 inches) (without rack brackets) 478 mm (18.82 inches) (with rack brackets) Maximum weight: 10.67 kg (23.53 lb) depending on your configuration Heat output: Approximate heat output: Minimum configuration: 130 BTU per hour (38 watts) Maximum configuration: 1720 BTU per hour (504 watts) Electrical input: Sine-wave input (50-60 Hz) required Input voltage low range: Minimum: 100 V AC Maximum: 127 V AC Input voltage high range: Minimum: 200 V AC Maximum: 240 V AC Input kilovolt-amperes (kVA), approximately: Minimum: 0.038 kVA Maximum: 0.504 kVA	Note: Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. The sound levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The noise emission level stated in the declared (upper limit) sound-power level, in bels, for a random sample of system. There is no keyboard connector or mouse connector on the server. You can connect a USB keyboard and USB mouse to the server by using the USB connectors.

EU Regulation 617/2013 Technical Documentation:

International Business Machines Corporation
New Orchard Road
Armonk, New York 10504
http://www.ibm.com/customersupport/

For more information on the energy efficiency program, go to http://www.ibm.com/systems/x/hardware/energy-star/index.html

Product Type:

Computer server

Year first manufactured:

2012

Internal/external power supply efficiency:

Maximum power (watts):

See Power supply.

Idle state power (watts):

Sleep mode power (watts):

Not applicable for servers.

Off mode power (watts):

Noise levels (the declared A-weighed sound power level of the computer):

See Acoustical noise emissions.

Test voltage and frequency:

230V / 50 Hz or 60 Hz

Total harmonic distortion of the electricity supply system:

The maximum harmonic content of the input voltage waveform will be equal or less than 2%. The qualification is compliant with EN 61000-3-2.

Information and documentation on the instrumentation set-up and circuits used for electrical testing:

ENERGY STAR Test Method for Computer Servers; ECOVA Generalized Test Protocol for Calculating the Energy Efficiency of Internal Ac-Dc and Dc-Dc Power Supplies.

Measurement methodology used to determine information in this document:

ENERGY STAR Servers Version 2.0 Program Requirements; ECOVA Generalized Test Protocol for Calculating the Energy Efficiency of Internal Ac-Dc and Dc-Dc Power Supplies.