Maintaining passwords using the CLI
You can use the command-line interface (CLI) to view and change the status of the password reset feature for the system.
Setting the maximum replication delay
You can use the chsystem command to set the maximum replication delay for the system. This value ensures that the single slow write operation does not affect the entire primary site.
Changing the locale setting using the CLI
You can use the command-line interface (CLI) to specify the locale for a system. The language that you select as your locale setting is used to display command results and error messages in the CLI.
Adding an enclosure to increase the size of the system You can add an enclosure to the system using the CLI or management GUI. An enclosure can be added to the system if the enclosure previously failed and is being replaced with a new enclosure or if a repair action has caused the enclosure to be unrecognizable by the system. Adding an enclosure to the system increases the capacity of the entire system.
Powering on and powering off the clustered system
To power on or to power off the system, complete the steps in this procedure in the order given. Use the procedure that applies to your generation of control enclosure model.
Changing the system topology
You can use the command-line interface or the management GUI to change the system topology.