Configuring the QLogic HBA for hosts that run the Windows Server operating system

After you install the QLogic HBA and the device driver on hosts that run a MicrosoftWindows Server operating system, you must configure the HBA.

For more information about supported QLogic models, see the following IBM website:

http://support.lenovo.com/us/en/products/servers/lenovo-storage

To configure the HBA BIOS, either use the QLogic HBA manager software or reboot into the Fast!UTIL tool. Configure the following settings:

Host Adapter BIOS: Disabled (unless the machine is configured for SAN Boot)
Adapter Hard Loop ID: Disabled
Connection Options: 1 - point to point only
LUNs Per Target: 0
Port Down Retry Count: 15

Set the execution throttle to a suitable queue depth for your environment, for example, a value of 100.

If you are using subsystem device driver (SDD) 1.6 or later, set Enable Target Reset to No. See Table 1 to include the required parameters for the registry key.

Table 1. Registry key parameters for QLogic models
Key	Required parameters
HKEY_LOCAL_MACHINE > SYSTEM > CurrentControlSet > Services > ql2`xxx` > Parameters > Device > DriverParameters	Buschange=0;FixupInquiry=1 Note: If you are using QLogic driver version 9.1.2.11 or later, Buschange cannot be set to zero. See your device driver documentation for details.