Use the startservice command to enter
a service state.
Syntax
sataskstartservice [ -force ] [ panel_name ]
Parameters
- satask
- System Administrator task; service commands that
are only used in specific circumstances.
- -force
- (Optional) Overrides checking of clustered system (system) membership.
Important: Using the force parameter might result
in a loss of access. Use it only under the direction of your product
support information .
- panel_name
- (Optional) Identifies the node being serviced.
Note: If panel_name is
not supplied, this applies to the node on which the command is running.
Description
This
command enters a service state. For example, you might use a service
state to remove a node from the candidate list, or to prevent it from
automatically being added to a system again.
The -force flag is required if the action could
interrupt I/O (last node in cluster or IO group). This command holds
the node in service state until it is cleared using the satask
stopservice command, or until the I/O process is restarted.
An invocation example
satask startservice
The
resulting output:
No feedback