Port settings for the HDS Thunder, Hitachi AMS 200, AMS 500, and AMS 1000, WMS100, and HDS TagmaStore WMS systems

Port settings are configurable at the port level.

The settings listed in Table 1 apply to disk controllers that are in a switch zone that contains Lenovo Storage V7000 nodes. If the system is shared between a Lenovo Storage V7000clustered system and another host, you can configure with different settings than shown if both of the following conditions are true:

The ports are included in switch zones.
The switch zones only present the ports directly to the hosts and not to a Lenovo Storage V7000 system.

There are no available options with the scope of a single controller.

Table 1. HDS Thunder, Hitachi AMS 200, AMS 500, and AMS 1000, WMS100, and HDS TagmaStore WMS system port settings supported by the Lenovo Storage V7000
Option	Default setting	Lenovo Storage V7000 required setting
Host connection mode 1	Standard	Standard
VxVM DMP mode (HDS Thunder 9200 only)	False	False
HP connection mode	False	False
Report inquiry page 83H (HDS Thunder 9200 only)	False	True
UA (06/2A00) suppress mode	False	True
HISUP mode	False	False
CCHS mode	False	False
Standard inquiry data expand (HDS Thunder 9200 only)	False	False
Host connection mode 2	False	False
Product ID DF400 mode	False	False
HBA WWN report mode (HDS Thunder 9200 only)	False	False
NACA mode	False	False
SUN cluster connection mode	False	False
Persistent RSV cluster mode	False	False
ftServer connection mode 1 (HDS Thunder 9200 only)	False	False
ftServer connection mode 2	False	False
SRC Read Command reject	False	False
Reset/LIP mode (signal)	False	False
Reset/LIP mode (progress)	False	False
Reset ALL LIP port mode	False	False
Reset target (reset bus device mode)	False	True
Reserve mode	False	True
Reset logical unit mode	False	True
Reset logout of third party process mode	False	False
Read Frame minimum 128 byte mode (HDS Thunder 950xxV only)	False	False
Topology	Point-to-point	Point-to-point