You must configure the operating system before you can use hosts that run the Linux operating system with the Lenovo Storage V7000 system.
Before you configure the host operating systems, the following
tasks must be completed:
- The Lenovo service representative must install the
system.
- You must install the appropriate host bus adapters.
After the prerequisite tasks are complete, use the following
general steps to configure your host system:
- Zone the host system to the system on the Fibre Channel SAN.
For more information, see the zoning details and zoning examples topics in the Configuring
section of this product information.
- Install a multipathing driver that is supported for Linux to enable the management of multiple
paths to system volumes.
- Create the host system on the system by using the worldwide port names (WWPNs). Map the
volumes to the host.
For more information, see the documentation on software installation and
configuration, and on the command-line interface.
- Create volumes or disks on your host by using a logical volume manager (LVM) or partition and
create file systems on the disks.