When a failure occurs on an optical link, the SFP transceiver
in the port providing the link might need to be replaced. To replace
a faulty SFP transceiver with a new one received from CRU or FRU
stock, use this procedure.
Even though many of these components are hot-swappable, they are
intended to be used only when your system is not active (no I/O operations). If your system
is powered on and processing I/O operations, go to the management GUI and follow the fix procedures. Initiating the replacement actions
without the assistance of the fix procedures can result in loss of
data or loss of access to data.
Be careful when
you are replacing the hardware components that are located in the
back of the system that you do not inadvertently disturb or remove
any cables that you are not instructed to remove.
CAUTION:
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following information: laser radiation when open.
Do not stare into the beam, do not view directly with optical instruments,
and avoid direct exposure to the beam.
Attention: When replacing this
part, you must follow recommended procedures for handling electrostatic
discharge (ESD) sensitive devices.
Important: For correct operation, use the correct SFP transceivers
with each adapter card. The topic
"Storwize V7000 2076-524 Gen2
replaceable units" identifies the suitable IBM parts.
- Use only 8G bps SFP transceivers in the 8 Gbps Fibre Channel adapter
cards.
- Use only 16 Gbps SFP transceivers in the 16 Gbps Fibre Channel
adapter cards.
- Use only 10 Gbps SFP transceivers in the 10 Gbps Ethernet (FCoE/iSCSI)
adapter card.
Complete the following steps to remove and then replace
an SFP transceiver.
- Carefully determine the failing physical port connection.
Important: Removing the wrong SFP transceiver might
result in loss of data access.
- Remove the cable from the SFP.
Figure 1 illustrates
an SFP transceiver.
Figure 1. SFP transceiver
- Remove the faulty SFP transceiver from
its aperture.
- Unclip the handle of the SFP transceiver.
- Pull on the handle of the SFP transceiver.
- The SFP transceiver slides
out of its slot.
- Install the replacement SFP transceiver into
the aperture that is vacated in step 3.
- Open the lock on the replacement SFP transceiver.
- Push the new SFP transceiver into
the aperture until it stops.
- Close the release handle.
- Gently pull the SFP transceiver.
If it is installed correctly, it does not move from its aperture.
- Reconnect the optical cable.
- Confirm that the error is now fixed. Either mark the error
as fixed or restart the node, depending on the failure indication
originally noted.