You can remove and replace enclosure end caps.
Attention: The left end cap is printed with information
that helps identify the enclosure.
- Machine type and model
- Enclosure serial number
The information on the end cap should always match the information
that is printed on the rear of the enclosure, and it should also match
the information that is stored on the enclosure midplane.
To remove and replace either the left or right end cap,
complete the following steps.
- If the enclosure is on a table or other flat surface, elevate
the enclosure front slightly or carefully extend the front over the
table edge.
- Grasp the end cap by the blue touch point and pull it until
the bottom edge of the end cap is clear of the bottom tab on the chassis
flange.
- Lift the end cap off the chassis flange.
- Fit the slot on the top of the new end cap over the tab
on the top of the chassis flange.
- Rotate the end cap down until it snaps into place.
Ensure that the inside surface of the end cap is flush with
the chassis.