Explanation
The node is unable to determine the WWNN that it
must use. This is because of the service controller or the nodes internal
drive being replaced.
User Response
Follow troubleshooting procedures to configure
the WWNN of the node.
- Continue to follow the hardware remove and replace procedure for
the service controller or disk.
- If you have not followed the hardware remove and replace procedures,
determine the correct WWNN. If you do not have this information recorded,
examine your Fibre Channel switch
configuration to see whether it is listed there. Follow the procedures
to change the WWNN of a node.
Possible Cause-FRUs or other: