Installing the support rails

Before installing an enclosure, you must first install support rails.

To install the support rails, complete the following steps.

1. Locate the rack mounting rails and screws (Figure 1).
   The rail assembly consists of two rails that must be installed in the rack cabinet.

   Figure 1. Rack mounting rails and screws
   

   

   
   
2. Remove the springs that are taped to one of the rails.
3. Attach a spring to the outside of each rail.
   1. Attach the circle end of the spring around the stud on the rail.
      (See Figure 2.)
   2. Pulling on the spring, attach the hook end of the spring to the tab on the rail.
      Figure 2. Installing the rail spring
      

      

      
      
4. Working at the front of the rack cabinet, identify the two standard rack units (2U) of space in the rack into which you want to install the support rails.
   Figure 3 shows two rack units with the front mounting holes identified.

   Figure 3. Hole locations in the front of the rack
   

   

   
   

   • 1 Upper rail mounting bracket pin
   • 2 Lower rail mounting bracket pin
   • 3 Rack mounting screw hole
5. Ensure that the appropriate bracket pins are installed in the front and rear bracket of each rail.
   Each rail comes with four medium pins preinstalled (two in the front bracket and two in the rear bracket). Large and small pins are provided separately. Use the pins that are appropriate for the mounting holes in your rack (see Table 1).

   Table 1. Selecting bracket pins for your rack.

   Mounting holes	Bracket pins
   Round, unthreaded	Use the preinstalled medium pins.
   Round, threaded	Unscrew the medium pins and replace with the smaller pins supplied with the rails.
   Square	Unscrew the medium pins and replace with the large pins supplied with the rails.

6. At each end of the rail, grasp the tab 1 and pull firmly to open the hinge bracket (see Figure 4).
   Figure 4. Opening the hinge brackets
   

   

   
   
7. Align the holes in the rail bracket with the holes on the front and rear rack cabinet flanges.
   Ensure that the rails are aligned on the inside of the rack cabinet.
8. On the rear of the rail, press the two bracket pins into the holes in the rack flanges.
9. Close the rear hinge bracket to secure the rail to the rack cabinet flange.
   (See Figure 5.)

   Figure 5. Closing hinge brackets and installing rear screw
   

   

   
   
10. On the front of the rail, press the two bracket pins into the holes in the rack flanges.
11. Close the front hinge bracket to secure the rail to the rack cabinet flange.
    (See Figure 5.)
12. Secure the rear of the rail to the rear rack flange with an M5 screw.
    (See Figure 5.)
13. Repeat the steps to secure the opposite rail to the rack cabinet.