Explanation
The node canister location information shows it
is in the correct enclosure, however the enclosure has had a new clustered
system created on it since the node was last shut down. Therefore,
the clustered system state data stored on the node is not valid.
User Response
Follow troubleshooting procedures to correctly
relocate the nodes.
- Check whether a new clustered system has been created on this
enclosure while this canister was not operating or whether the node
canister was recently installed in the enclosure.
- Follow the "Procedure: Getting node canister and
system information using the service assistant" task, and check
the partner node canister to see if it is also reporting node error
508. If it is, check that the saved system information on this and
the partner node match.
If the system information on both nodes
matches, follow the "Replacing a control enclosure midplane" procedure
to change the enclosure midplane.
- If this node canister is the one to be used in this
enclosure, follow the "Procedure: Removing system data from a node
canister" task to remove clustered system data from the node canister.
It will then join the clustered system.
- If this is not the node canister that you intended to use, follow
the "Replacing a node canister" procedure to replace the node
canister with the one intended for use.
Possible Cause—FRUs or other:
- Service procedure error (90%)
- Enclosure midplane (10%)