lsservicenodes

Use the lsservicenodes command to display a list of all the nodes that can be serviced by using the service assistant CLI.

Syntax

sainfo lsservicenodes

Parameters

None

Description

This list includes nodes that are at a code level of at least 6.2.0, are visible on the fabric, and are one of the following candidates:

The partner node in a control enclosure to the node that is running the command.
In the same clustered system (system) as the node that is running the command.
In candidate state.
Not in a system and in service state.
Not in an enclosure with a stored system ID (which is not the system ID of the local node).

Nodes participating in a different system are not be shown unless they are the partner node. lsservicenodes outputs shows possible outputs.

Table 1. lsservicenodes outputs
Attribute	Value
panel_name	Indicates the front panel name, enclosure IDs, or canister IDs that identify the node. Note: You can find out the `panel_name` for each of your nodes by issuing lsservicenodes.
cluster_id	Indicates the system ID. Blank if node is a candidate; otherwise, the value is determined from vpd_cluster.
cluster_name	Indicates the system name. The value is blank if node is a candidate; otherwise, the value is determined from `vpd_cluster`.
node_id	Indicates the node ID. The value is blank if node is a candidate; otherwise, the value is determined from `vpd_cluster`.
node_name	Indicates the node name. The value is blank if node is a candidate; otherwise, the value is determined from `vpd_cluster`.
relation	Indicates the relationship. The values are: `local` indicates that the node the CLI command was issued from. `partner` indicates that the node is in the same enclosure as the local node. `cluster` indicates that nodes other than the partner that is in the same system as the local node. `candidate` indicates that the node is not part of the system.
node_status	Indicates the node status. `active` indicates that the node is part of a system and can perform I/O. `service` indicates that the node is in service, standby, or node rescue. `candidate` indicates that the node is not part of a system. `starting` indicates that the node is part of a system and is attempting to join the system, and cannot perform I/O.
error_data	Indicates the outstanding error and error data, by priority.

An invocation example

sainfo lsservicenodes

The resulting output:

panel_name cluster_id       cluster_name        node_id node_name relation  node_status error_data
01-1       0000020073C0A0D4 Cluster_9.180.28.82 1       node1     local     Active
01-2       0000020073C0A0D4 Cluster_9.180.28.82 2       node2     partner   Active