Syntax
addcontrolenclosure -iogrp io_grp_id_or_name -sernum enclosure_serial_number [ -site { site_name | site_id } ]
Parameters
- -iogrp io_grp_id_or_name
- The I/O group in which you want to put the control enclosure.
- -sernum enclosure_serial_number
- The serial number of the control enclosure you want to add.
- -sitesite_name | site_id
- (Optional) Specifies the numeric site value or site name of the new control enclosure. The site
can be set to a value of 1 or 2 only.
Note: The site that is assigned to a control enclosure
cannot be changed if the topology is hyperswap.
Description
Use this command to add a control enclosure to the system.
Note: Transparent cloud tiering can be enabled on a system if
every node on the system supports it. If a system supports transparent cloud tiering, you cannot add
nodes that do not support it to the system.
Compressed or thin deduplicated volumes can be added only to systems in which
all nodes support deduplicated volumes. You can add only nodes that support deduplicated volumes to
a system that contains compressed or thin deduplicated volumes. Nodes can be added only to a system
that contains compressed or thin deduplicated volumes if that new node can support the amount of
memory that is allocated for data deduplication in the target I/O group.
An invocation example
addcontrolenclosure -iogrp 0 -sernum 2361443
The following output is displayed:
Enclosure containing Node, id [x], successfully added
An
invocation example
addcontrolenclosure -iogrp 1 -sernum 1234567 -site site2
The following output is displayed:
Enclosure, Node id [2], successfully added