Explanation
The 530 error code is followed
by two numbers. The first number is either 1 or 2 to indicate which
power supply has the problem.
The second number is either 1,
2 or 3 to indicate the reason.
- 1
- The power supply is not detected.
- 2
- The power supply failed.
- 3
- No input power is available to the power supply.
If the node is a member of a cluster, the cluster reports
error code 1096 or 1097, depending on the error reason.
The
error will automatically clear when the problem is fixed.
User Response
- Ensure that the power supply is seated correctly and that the
power cable is attached correctly to both the node and to a power
source.
- If the error has not been automatically marked fixed after two
minutes, note the status of the three LEDs on the back of the power
supply.
- If the power supply error LED is off and the AC power LEDs are
on, this is the normal condition. If the error has not been automatically
fixed after two minutes, replace the system board.
- Follow the action specified for the LED states noted in the list
below.
- If the error has not been automatically fixed after two minutes,
contact support.
Error, AC: Action
ON,ON or OFF,ON or OFF:The power supply
has a fault. Replace the power supply.
OFF,OFF,OFF:There is
no power detected. Ensure that the power cable is connected at the
node and to a power source. If the AC LED does not light, check your
power source. If you are connected to a 2145 UPS-1U that is showing
an error, follow MAP 5150 2145 UPS-1U. Otherwise, replace the power
cable. If the AC LED still does not light, replace the power supply.
OFF,OFF,ON:The power supply has a fault. Replace the power supply.
OFF,ON,OFF:Ensure that the power supply is installed correctly.
Possible Cause-FRUs or other:
Reason 1: A power supply is
not detected.
- Power supply (19%)
- System board (1%)
- Other: Power supply is not installed correctly (80%)
Reason 2: The power supply has failed.
- Power supply (90%)
- Power cable assembly (5%)
- System board (5%)
Reason 3: There is no input power to the power supply.
- Power cable assembly (25%)
- UPS-1U assembly (4%)
- System board (1%)
- Other: Power supply is not installed correctly (70%)