Explanation
Some of the tests that are performed during node
startup did not complete because some of the data reported by the
uninterruptible power supply during node startup is inconsistent because
of a software error in the uninterruptible power supply. The node
has determined that the uninterruptible power supply is functioning
sufficiently for the node to continue operations. The operation of
the cluster is not affected by this error. This error is usually resolved
by power cycling the uninterruptible power supply.
User Response
- Power cycle the uninterruptible power supply at a convenient time.
The one or two nodes attached to the uninterruptible power supply
should be powered off before powering off the uninterruptible power
supply. Once the nodes have powered off, wait 5 minutes for the uninterruptible
power supply to go into standby mode (flashing green AC LED). If this
does not happen automatically then check the cabling to confirm that
all nodes powered by this uninterruptible power supply have been powered
off. Remove the power input cable from the uninterruptible power supply
and wait at least 2 minutes for the uninterruptible power supply to
clear its internal state. Reconnect the uninterruptible power supply
power input cable. Press the uninterruptible power supply ON button.
Power on the nodes connected to this uninterruptible power supply.
- If the error is reported again after the nodes are restarted replace
the 2145 UPS electronics assembly.
Possible Cause-FRUs or other:
- 2145 UPS electronics assembly (5%)
Other:
- Transient 2145 UPS error (95%)