If you installed an optional 1 Gbps iSCSI 4-port host interface adapter, you can use Ethernet cables to connect the system to your Ethernet SAN.
Each
system has two
Ethernet ports, port 1 and port 2, that are built into the canister. When a 4-port Ethernet
host interface adapter is installed, the port number starts at 3.
Note: The Ethernet cables are
connected in pairs. Both canisters must have the same number of cables connected.
To install the cables, complete the following steps.
- Identify the correct pair of Ethernet cables for the Ethernet ports labeled 3 in the left canister and the right canister.
- Connect the appropriate cable to each port.
- For each additional pair of Ethernet ports in the right and left canisters, identify the correct pair of cables and connect them.
Example of a Lenovo Storage V3700 V2 system with a 4-port Ethernet host interface adapter shows
the Ethernet ports on a node canister, as seen from the back of a Lenovo Storage V3700 V2 system.
Figure 1. Example of a Lenovo Storage V3700 V2 system
with a 4-port Ethernet host interface adapter
