Add a control enclosure
to an existing system.
To complete this step, you must use a supported web browser.
Verify that you are using a supported web browser from the following
website:
https://datacentersupport.lenovo.com/
To add another control enclosure into an existing system,
complete the following steps:
- Configure the Fibre Channel switch to allow for correct
zoning between the control enclosures.
The correct zoning
provides a way for the Fibre Channel ports to connect to each other.
If the configuration tool for the Fibre Channel switch does not provide details of the worldwide
port names (WWPNs), use the service assistant to find them or use the USB flash drive to find the status of the node. See the "Troubleshooting" topic that is available from the
Storwize V5000 Information Center.
- Start the management GUI.
- Go to .
- On the System page, select .
- Continue to follow the on-screen instructions.
This step completes
the quick installation procedures. If you are setting up for the first
time, see the configuring topics and continue to follow the tasks
available in Getting Started from the management GUI.
If you added another control enclosure into an existing system, continue
to do your standard tasks.