Use this command to obtain service assistant access to a node canister even if the current state of the node canister is
unknown. The physical access to the node canister is required and is
used to authenticate the action.
Syntax
satask chserviceip -serviceipipv4 [ -gwipv4 ] [ -maskipv4 ] [ -resetpassword ]
satask chserviceip -serviceip_6ipv6 [ -gw_6ipv6 ] [ -prefix_6int ] [ -resetpassword ]
satask chserviceip -default [ -resetpassword ]
Parameters
- -serviceipipv4
- (Optional) The IPv4 address for the service assistant.
- -gwipv4
- (Optional) The IPv4 gateway for the service assistant.
- -maskipv4
- (Optional) The IPv4 subnet for the service assistant.
- -serviceip_6ipv6
- (Optional) The IPv6 address for the service assistant.
- -gw_6ipv6
- (Optional) The IPv6 gateway for the service assistant.
- -default
- (Optional) Resets to the default IPv4 address.
- -prefix_6int
- (Optional) The IPv6 prefix for the service assistant.
- -resetpassword
- (Optional) Sets the service assistant password to the default
value.
Description
This command resets the service assistant
IP address to the default value. If the command is
run on left canister, the
default value is 192.168.70.121 subnet mask: 255.255.255.0. If the command is run on right
canister, the default value is 192.168.70.122 subnet mask:
255.255.255.0. If the node
canister is active in a system,
the superuser password for the system is reset; otherwise, the superuser password is reset on the
node
canister.
If the node canister
becomes active in a system, the superuser password is reset to that of the system. You can configure
the system to disable resetting the superuser password. If you disable that function, this action
fails.
This action calls the satask chserviceip command and the
satask resetpassword command.