Configuration settings for Hitachi HUS 100 familystorage systems

The web browser access enables the intuitive setup of the Hitachi HUS 100 familystorage system logical unit numbers (LUNs) and export to the system.

The setup is straightforward and default settings can be used. A LUN must be presented to the system before the system can detect the controller.

To configure the Hitachi HUS 100 familystorage systems, follow these steps:

Select Host Options > Groups > Host Groups. Then, select Create Host Group.
Select Host Group Property.
Choose a name. To select all ports, select Ports. Select Forced set to all available ports. .
On the WWN tab, select from the selected list. From pages, add all of the system and Hitachi HUS 100 family ports.
On the Volumes tab, choose from Available Volumes and add the required volumes. You can use the defaults or set the H-LUN either by all or individually. Verify that you have the required paths and set all the ports.

On the Options tab, use the default settings as shown.

Summary  
Name  001:iop3                                      Platform  not specified  
Port  0A                                                  Middleware  not specified  
 

Common Setting --> Standard Mode  
Mode Name                                    Mode Enable 
 
No Object 
HP-UX Mode                                      No  
PSUE Read Reject Mode                           No  
Mode Parameters Changed Notification Mode       No  
NACA Mode                                       No  
Task Management Isolation Mode                  No  
Unique Reserve Mode 1                           No  
Port-ID Conversion Mode                         No  
Tru Cluster Mode                                No  
Product Serial Response Mode                    No  
Same Node Name Mode                             No  
CCHS Mode                                       No  
NOP-In Suppress Mode                            No  
S-VOL Disable Advanced Mode                     No  
Discovery CHAP Mode                             No  
Unique Extended COPY Mode                       No  
Unique Write Same Mode                          No  
Unique Compare Write Mode                       No  
DP Depletion Detail Reply Mode                  Yes     
Unit Attention Change Mode                      No  

The DP Depletion can be No to remove for TP warnings in SVC errlog.

Volume Options → Groups → Volumes → Default settings;
→ Mapping guard                    Disabled

→ Mapping Mode                     Enabled  
 
→ Format Mode
  Format Priority Mode             Normal 
  Format Data                      Zero Data