Use the rescuenode command to start
automatic recovery for a specific node.
Syntax
satask rescuenode -force [ panel_name ]
Parameters
- panel_name
- (Optional) Identifies the node being serviced.
Note: If panel_name is
not supplied, this applies to the node on which the command is running.
- -force
- (Required) The -force parameter is required because this service action can
cause temporary or permanent loss of access to data. Use this command only when the node reports
corrupted system code.
Important: Using the force parameter might result in a loss of
access. Use it only under the direction of the IBM Support Center.
Description
This command starts automatic recovery for a specific node. Use this command only when the node
reports corrupted code.
An invocation example
satask rescuenode -force 112233
The
resulting output:
No feedback